Is it permissible to add the TC/PC-holder’s part number to a PMA part (as a part of the PMA holder’s approved design)? Continue reading
A PMA applicant must assigns a part number to the PMA part. The nature of that part number was a topic of discussion at a recent industry meeting, the 2011 Gorham Conference. The discussion focused on the extent to which a PM Apart can resemble (or not resemble) the OEM part number for the OEM corollary part. Continue reading
I’ve received some recent questions about the eligibility marking on PMA parts. This requirement to mark eligibility on PMA parts was removed by a recent rule change, but compliance with the the rule change is not authorized until April 2011. This poses a challenge for current PMA applicants who may be faced with the choice of delaying a PMA application until after April 2011 in order to take advantage of the new (more limited) marking requirements. Obviously, delay is not a preferred approach, because it delays the benefits to the industry that the PMA part would represent. In this article, we examine the regulatory basis for the change, as well as one possible way to address the impending change in the the marking requirements in a way that maintains compliance while also permitting the part to easily take advantage of the marking changes that take effect in April 2011. Click on the article title to read the entire article. Continue reading
You must be logged in to post a comment.