Archives

FAA Design Approval

This category contains 100 posts

Fuel Efficiency Metric NPRM – New Rule Could Affect PMAs and STCs

The FAA is proposing a new set of standards applicable to aircraft. While the proposed rule suggests that only the large airframe manufacturers would be affected, the plain language of the rule appears to impose obligations on a wide variety of manufacturers and repair stations. Companies developing PMAs and/or STCs should be concerned about the … Continue reading →

Preview FAA Rulemaking by Examining Advisory Committee Reports

One way to tell what is coming over the horizon for FAA regulations and policies is to examine the advisory committee reports that are being submitted to the FAA. The DOT’s Safety Oversight and Certification Advisory Committee (SOCAC) has accepted three reports for submission to the FAA: Compliance Assurance System Report — https://www.faa.gov/regulations_policies/rulemaking/committees/documents/index.cfm/document/information?documentID=4829 Technical Standard … Continue reading →

FAA: Virtual Evaluation Is Here to Stay

The FAA plans to remain in a maximum telework environment. This means that they will be maximizing the use of remote technologies; but FAA personnel will also be permitted to perform onsite oversight where that is warranted. The FAA has stressed that there is no limitation or prohibition that would restrict the FAA from performing … Continue reading →

FAA Authorizes Remote Inspection/Testing for FAA Employees, Designees, and Manufacturers

FAA has issued remote inspections and testing guidance. The guidance applies to tasks performed by both FAA employees and designees. This guidance can also be used by PMA companies issuing 8130-3 tags. Continue reading →

FAA Plans for Continued Oversight During Covid-19 Crisis

FAA is taking steps to enable aviation to continue doing business during the Covid-19 Crisis Continue reading →

Can You Add the OEM’s Part Number to a PMA Part?

Is it permissible to add the TC/PC-holder’s part number to a PMA part (as a part of the PMA holder’s approved design)? Continue reading →

FAA Remote Test Witnessing Policy Open for Comment

The FAA has issued a draft policy statement that would enable FAA-authorized witnesses to remotely witness certain engineering tests via video. Although limited in scope the policy could prove beneficial by allowing necessary test witnesses to do so remotely rather than in person. Continue reading →

PMA Parts Must be Marked – But Drawings? There are Options!

The FAA has clarified the PMA marking requirements as they apply to PMA drawings. The clarification opens up a new mechanism for companies to streamline their processes. Continue reading →

FAA-AIR Transformation Process Continues

The FAA is continuing to implement its AIR transformation, and will soon begin realigning the organization. This will be the first step of the transformation visible to industry. Continue reading →

Challenges Apparent in Reconciling Performance Based Regulations and Emerging Technologies

MARPA had the opportunity this week to attend the 2016 FAA-EASA International Aviation Safety Conference that was held in Washington, DC. The conference provides an opportunity for the regulatory agencies and industry to get together to discuss emerging issues in aviation safety and strengthen the cooperation between both the regulators themselves as well as the … Continue reading →